These Soft Loops will enable you to carry IWB with your Statureman Modular Holster.
Made in-house with Mil-Spec Pull-the-Dot Snaps and coated material that holds your pistol in place. They are adjustable to accommodate belt sizes from 1.25 in to 2 in.
Please note: the snaps on these loops may be very tight to start out. A flat blade screw driver or similar tool will allow you to snap them open. Insert it between the snap heads on the outside of the loop at the top and twist to open. The snaps will loosen up with repeated use. (You may cut off excess sizing length without voiding the warranty, but the warranty will only apply to the remaining material.)
--------------------------------------------------------------------------------
 |
| Product may differ from shown. |
Made in-house with our IWB Soft Loops, Tuckable IWB Soft Loops allow you to tuck your shirt in over the gun for complete concealment. Strut is Injection molded.
They are adjustable to accommodate belt sizes from 1.25 in to 2 in.
Run fixed with two screws in (as shown), or just one screw in each to allow for rotation and better comfort. Plates can also be removed for untucked IWB carry as well. Simply use the longer screws that come packed with the loops. (You may cut off excess length soft loop material without voiding the warranty, but the warranty will only apply to the remaining material.)
If you own IWB soft loops already you can purchase the tuckable plates in the menu to add tuckability.
----------------------------------------------------------------------------------------------------------------------------------------------
IWB Clips
Injection molded clips are Configurable for both IWB and Tuckable IWB, by using different spacers. NOTE: Attachment hole spacing is for our Modular OWB holsters.
--------------------------------------------------------------------------------
A/IWB Holster Clips and Loops
Run a Statureman A/IWB tuckable holster and want to swap out different types of clips or loops for different carry? Purchase additional Clips and Strut/Loop Assemblies here:
-Hole spacing for the clips/loops listed here are made to match our A/IWB holster line at 1/2 inch on center and are NOT compatible/will not fit on our Full size Modular holster line.
-Strut and loop assembly is adjustable from 1.25 inch to 2 inch belts and does not require spacers.
-Rubber spacers are required for sclips and are sold separately. Spacers are interchangeable between clip types.
